Close Privacy Overview This website uses cookies to improve your experience while you navigate through the website. Out of these, the cookies that are categorized as necessary are stored on your browser as they are essential for the working of basic functionalities of the website.
We also use third-party cookies that help us analyze and understand how you use this website. These cookies will be stored in your browser only with your consent. You also have the option to opt-out of these cookies. But opting out of some of these cookies may affect your browsing experience. Necessary Necessary. The keypad should now be set to the new PIN. These include models , , , , , , and , , , , , Looking up at the bottom of the Genie motor head cover in your garage you will see a set of black buttons depicted in the drawing below along with two LED lights shown here in grey.
This keypad has no cover and is connected to the inside receiver by the special ribbon attached to the keypad. The outside garage door opener keypad has a flat ribbon, which slides behind the garage door molding into the garage and attaches to the keyless entry receiver box.
Slide the receiver switch back to RUN. Cleveland: Akron: Royalton Road Broadview Hts. While holding down on the and 8 keys at the same time slide the cover up the rest of the way until it clicks or latches. Release the and 8 keys. Close the cover. Open the cover back up and press in order the 3, 5, 7 and keys. Enter your PIN of your choice and press the button.
Your PIN can be up to 8 digits. Do not use the or star key. Slide the receiver switch back to RUN. Test your PIN code followed by the star button.
The square smart button is located on the side or the back of the motor head, and is colored red, green, amber, orange, or purple. It is directly under the 1 wire terminal screw. Record the dip switch sequence before performing steps. For every switch in the ON or positive position record a 1, for every switch in the OFF or negative position record a 2. Back light should turn off after step 4.
Once your keypad is programmed you can change this code in the future. While pressing the and 8 buttons simultaneously, slide the Keypad Cover the rest of the way up until it latches. Release and 8 buttons.
At this point, if the back lit keypad light stays on, proceed directly to step 2. If the back lit keypad light goes out, close the cover pad and reopen it until it clicks. Proceed to step 2. Press 3, 5, 7 and buttons in said order. Enter your PIN and press the button. Your PIN number can be created from any group of numbers up to 8 digits of your choice. Slide Keypad Cover down. Test Keypad by sliding cover up until it latches. Your door should operate. Indicator light will blink once and go out.
Close cover fully. To Program the Intellicode Wireless Keypad Open cover fully by sliding keypad cover up until it latches. Press Proceed to Part 2 below. Enter your PIN number after pressing the Learn Code button described above, while the motor head indicator light is blinking.
Adding More Doors to Keypad: Open cover fully. Enter PIN 1.
0コメント